LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Electronic Control Modules (Service Information) 1500) >> Module, Integrated Trailer Brake (ITBM) >> Removal >> Removal

Module, Integrated Trailer Brake (ITBM): Removal: Removal

WARNING: This page is about a different car, the 2016 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Column Opening Cover & Fasteners
GC0086792Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the steering column opening cover retaining screws (2).
  3. Using a trim stick, remove the steering column opening cover (1) from the instrument panel and position aside.
    Fig 2: Instrument Panel Side Cover
    GC0089023Courtesy of CHRYSLER GROUP, LLC
  4. Using a trim stick, from the notch on the bottom, remove the left instrument panel side cover (1). May need to remove the door seal for better access to the side panel cover.
    Fig 3: Integrated Trailer Brake Module (ITBM) & Electrical Connectors
    GC0137095Courtesy of CHRYSLER GROUP, LLC
  5. From under the instrument panel, disconnect the integrated trailer brake module (ITBM) electrical connectors (1).
    NOTE:

    One screw on the right front of the ITBM not shown in illustration.

  6. Remove the ITBM retainer screws.
    NOTE:

    There is a retainer clip on each side of the ITBM near the bottom.

  7. Using a trim stick, remove the ITBM from the IP.
scientia non olet · About LEMON Manuals