Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE STATUS OF THE ERROR MESSAGE
NOTE:
Make sure the vehicle being tested is a CAN BUS VEHICLE. If not, false error messages may be displayed.

NOTE:
Make sure the scan tool is updated to the latest software.
1. Using the scan tool, record the error message.
2. Disconnect the scan tool from the Data Link Connector (DLC).
3. Cycle the ignition from on to off three times.
4. Turn the ignition on.
  Does the scan tool display this same error message?
  
  Yes
  - Go To 2.
  No
  - The conditions that caused this error message to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
DIAGNOSTIC CAN C CIRCUITS SHORTED TO VOLTAGE

Fig 1: Measuring Voltage Of Diagnostic CAN C Circuits
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Totally Integrated Power Module C7 harness connector.
3. Disconnect the scan tool from the DLC.
4. Turn the ignition on.
5. Measure the voltage of the Diagnostic CAN C circuits.
  Is the voltage above 6.0 volts for either circuit?
  
  Yes
  - Repair the Diagnostic CAN C circuits for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Inspect the wiring and connectors for damage or shorted circuits. If ok, replace the Totally Integrated Power Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .