Diagnostic Test
WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- OTHER DTCS
- With the scan tool, read DTCs.
Are other DTCs present?
Yes
- Troubleshoot other DTCs first.
No
- Go To 2.
- With the scan tool, read DTCs.
- POWERTRAIN CONTROL MODULE
- Interview customer. This fault can be set if the customer coasts to a vehicle speed below 2 mph (3 kmh) by using the parking brake or exhaust brake.
Did the customer coast to a near stop without using the service brake?
Yes
- Explain diagnostic operation to customer. Repair complete.
No
- Replace the Powertrain Control Module in accordance with the service information.
- Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
- Interview customer. This fault can be set if the customer coasts to a vehicle speed below 2 mph (3 kmh) by using the parking brake or exhaust brake.