Quad Headlamps
WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
NOTE:
There are access covers (6) installed over both headlamp bulb access holes in the quad front lamp unit housing. The illustration shows the cover for the low beam bulb removed for reference; however, both covers MUST be reinstalled prior to returning the vehicle to service.
- Remove the front lamp unit (1) from the vehicle. Refer to LAMP .
- Rotate the appropriate low beam (upper) or high beam (lower) access cover (6) on the back of the front lamp unit housing counterclockwise to unlock and remove it.
- Firmly grasp the appropriate headlamp bulb (5) in the reflector through the opening on the back of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the bulb straight out from the keyed opening in the reflector far enough to access and disconnect the front lamp unit pigtail wire harness connector from the bulb connector receptacle.
- Remove the headlamp bulb from the lamp.