LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 917 (Lamps/Lighting - Exterior (Service Information) 2500 Hd & 3500 Hd) >> Lamp, Tail Stop Turn >> Removal >> Bulb

Lamp, Tail Stop Turn: Removal: Bulb

WARNING: This page is about a different car, the 2015 RAM 3500 HD and 2015 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Lamp Unit, Bulb Socket & Connector
GC0087654Courtesy of CHRYSLER GROUP, LLC
NOTE:

The rear lamp unit contains two bulbs: park/stop/turn signal/side marker and backup. The service procedures for each bulb are the same, only the bulb sizes and types may differ.

  1. Disconnect and isolate the battery negative cable.
  2. Remove the rear lamp unit (1) from the end of the box side panel. Refer to LAMP  .
  3. Disconnect the chassis wire harness connector (3) from the park/stop/turn signal/side marker bulb socket (2) on the back, or the backup (4) bulb socket on the bottom of the lamp housing.
  4. Firmly grasp the socket on the lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
  5. Pull the socket and bulb straight out from the keyed opening in the housing.
  6. Pull the base of the bulb straight out of the socket.
scientia non olet · About LEMON Manuals