Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

IN PLANT TEST FAILURE
1. Ignition on, engine not running.
  NOTE:
  This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range.
2. With a scan tool, select View DTCs.
3. With the scan tool, erase DTCs.
4. Start the engine.
5. With the scan tool, View DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Go To 2.
  No
  - Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Refer to INTERMITTENT CONDITION .
APPS RELEARN
1. With a scan tool select the ETC RELEARN function.
2. Next, erase DTCs.
3. Start the engine.
  Does the DTC return?
  
  Yes
  - Replace the APPS Assembly per Service Information. After installation is complete, use a scan tool and select the ETC RELEARN function.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Test Complete.