LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Lamps/Lighting - Exterior (Service Information) 2500 Hd & 3500 Hd) >> Smart Beam >> Standard Procedure >> Smart Beam Calibration >> Vehicle Preparation For SMARTBEAM® Calibration

Vehicle Preparation For SMARTBEAM® Calibration

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Be certain that the imager lens and the windshield glass in front of the imager lens are clean and free from obstructions.
  2. Be certain that the inside rear view mirror mounting is properly tightened and secure.
  3. Repair or replace any ineffective, worn or damaged suspension components that could hinder proper SmartBeam® calibration.
  4. Verify proper tire inflation pressures.
  5. Remove any accumulations of mud, snow or ice from the vehicle underbody.
  6. Verify that there is no load in the vehicle (cargo or passengers), except for the driver.
  7. The fuel tank should be FULL. Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated gallon of missing fuel.
  8. Verify correct vehicle suspension height.
  9. Verify that the vehicle has at least 16 kilometers (10 miles) showing on the odometer.
scientia non olet · About LEMON Manuals