LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 352 (Lamps/Lighting - Exterior (Service Information) 2500 Hd & 3500 Hd) >> Switch, Parking Brake >> Diagnosis And Testing >> Diagnosis And Testing - Park Brake Switch >> Indicator Remains Illuminated - Brake System Checks Okay

Indicator Remains Illuminated - Brake System Checks Okay

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable. Disconnect the body wire harness connector for the park brake switch from the switch terminal. Check for continuity between the terminal of the park brake switch and a good ground. There should be no continuity with the park brake released, and continuity with the park brake applied. If OK, go to  2. If not OK, replace the ineffective park brake switch.
  2. Disconnect the instrument panel wire harness connector (Connector C2) for the instrument cluster from the cluster connector receptacle. Check for continuity between the park brake switch sense circuit cavity of the body wire harness connector for the park brake switch and a good ground. There should be no continuity. If not OK, repair the shorted park brake switch sense circuit between the park brake switch and the instrument cluster as required.
scientia non olet · About LEMON Manuals