LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1912 (6.7L Diesel - DTCS P24B4-00 To U3017-00 - 2500HD & 3500HD) >> DTC Troubleshooting >> P2563-00-Turbocharger Boost Control Position Sensor Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR ACTIVE DTC 
    NOTE:

    If there are any communication related DTCs active, perform those diagnostics before continuing with this diagnostic tree.

    NOTE:

    If there are any Turbocharger Speed Sensor, Position, or Control circuit related DTCs active, perform those diagnostics before continuing with this diagnostic tree.

    1. Turn the ignition on.
    2. With the scan tool, read DTCs.

      Is DTC P2563 active?

      Yes 

      • Go To  2

      No 

  2. ELECTRONIC TURBO ACTUATOR 
    NOTE:

    It is important to drain engine coolant before Electronic Turbo Actuator removal.

    1. Remove the Electronic Turbo Actuator from the turbocharger.
    2. Inspect Electronic Turbo Actuator for a broken drive gear.

      Is the VGT actuator drive gear broken/damaged?

      Yes 

      No 

      • Go To  3
  3. TURBOCHARGER 
    1. Inspect the sector gear on the turbocharger for damage or broken teeth.
    2. Move the sector gear lever on the turbocharger bearing housing up and down from stop to stop.
    3. Check for smooth movement between the stops.
      NOTE:

      The actuator lever must move evenly and crisply as it is moved.

      Does the nozzle slide evenly from stop to stop and are the gear teeth undamaged?

      Yes 

      No