When Monitored

WARNING: This page is about a different car, the 2019 RAM 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

The TCM supply voltage is between 10.0 and 16.0 volts.
Ignition switch Run position signal is detected via dedicated circuit to TCM.
There are no ignition switch failures.
Engine speed (CAN Message) is greater than 550 RPM.
No CAN bus failures.
No Turbine Speed Sensor DTCs set.
No Linear or On/Off Solenoid DTCs set.
No Transmission range sensor DTCs set.
No hydraulic pressure circuit high DTCs set.
No gear ratio failures for any previously commanded gears.
The transmission is not currently shifting for a calibrated amount of time.
Linear solenoid No. 5 command pressure is greater than or equal to 600 kPa (102 psi).