Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR A DTC C1232-DRIVE TEST: PRESSURE SENSOR
NOTE:
This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, read and record DTC's.
3. With the scan tool, read and record Freeze Frame information.
4. Perform ECU initialization with drive test. Refer to ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
5. Start the engine.
6. With the scan tool, read and record DTC's.
  Does the scan tool display: C1232-DRIVE TEST: PRESSURE SENSOR?
  
  Yes
  - Go To 2.
  No
  - Perform the ABS INTERMITTENT CONDITION diagnostic procedure. Refer to ABS INTERMITTENT CONDITION .
CHECK HYDRAULIC SYSTEM AND BRAKE SYSTEM COMPONENT INSTALLATION AND FUNCTION
1. Verify that the Antilock Brakes Module and Hydraulic Control Unit are properly installed.
2. Verify that the hydraulic system is properly filled and bled.
3. Verify that the brake system components are installed and functioning properly.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Replace the ECU in accordance with the Service Information.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .