LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Anti-Lock Brake System (Abs) - Electrical Diagnostics - 3500 Cab & Chassis, 4500 & 5500) >> Diagnosis And Testing >> C1078-Tire Revolutions Range Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. DTC CONDITION IS PRESENT 
    1. Turn the ignition on.
    2. Observe the ABS Warning Indicator.

      Is the ABS Warning Indicator Flashing?

      Yes 

      • Go To  2.

      No 

      • Go To  3.
  2. INCORRECT TIRES PROGRAMMED INTO TIPM 
    TIRE SIZE BODY STYLE ENGINE SIZE SALES CODE TIRE CIRCUMFERENCE
    305/40R22 GENERAL ALL SEASON DS ALL TY4 2461mm (97in)
    305/40R22 GENERAL ALL SEASON DS ALL TYE 2461mm (97in)
    P245/70R17 BSW GOOD YEAR ALL SEASON DS ALL TSB 2353mm (93in)
    P275/60R20 BSW GOOD YEAR ALL SEASON DS ALL TTJ 2538mm (100in)
    LT275/70R17C OWL GOOD YEAR ALL TERRAIN DS ALL TTL 2480mm (98in)
    P265/70R17 BSW GOOD YEAR ALL SEASON DS ALL TTM 2450mm (96in)
    P265/70R17 BSW GOOD YEAR ON/OFF ROAD DS ALL TTS 2420mm (95in)
    P265/70R17 OWL GOOD YEAR ON/OFF ROAD DS ALL TTK 2435mm (96in)
    P265/70R17 OWL GOOD YEAR ON/OFF ROAD DS ALL TTT 2435mm (96in)
    P265/70R17 OWL GOOD YEAR ALL SEASON DS ALL TTY 2450mm (96in)
    P275/60R20 OWL GOOD YEAR ALL SEASON DS ALL TUK 2538mm (100in)
    1. Inspect all four tires on the vehicle and note the size of each tire.
      NOTE:

      A non-production size tire cannot be programmed into the TIPM. The production Powertrain, with the production size tires, is the only emissions certified configuration that is available for reprogramming.

    2. Verify the correct Tire/wheel information is programmed in the TIPM.

      Is the correct value programmed in the TIPM according to the chart?

      Yes 

      No 

      • Program the correct Tire/Wheel information in the TIPM.
      • Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  3. WIRING HARNESS INSPECTION 
    1. Turn the ignition off.
    2. Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
    3. Visually inspect the related wire harness connectors. Look for broken, bent, pushed out, or corroded terminals.
    4. Perform any Hotline letters or Technical Service Bulletins that may apply.

      Were any problems found?

      Yes 

      No 

      • Test Complete.