LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1833 (6.7L Engine (Service Information) - 2500HD & 3500HD) >> Fuel Injection >> Sensor, Crankshaft Position >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

  1. Disconnect and isolate the negative battery cable(s). Refer to STANDARD PROCEDURE .
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0185105Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Crankshaft Position (CKP) sensor wire harness connector (1).
    GC0185701Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolt (1) and the CKP sensor (2).

INSTALLATION 

GC0185701Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate the O-ring seal with clean engine oil and install the Crankshaft Position (CKP) sensor (2) and tighten bolt (1) to the proper specification. Refer to TORQUE SPECIFICATIONS .
    GC0185105Courtesy of CHRYSLER GROUP, LLC
  2. Connect the CKP sensor wire harness connector (1).
  3. Remove support and lower the vehicle.
  4. Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals