LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 ((Heating & Air Conditioning (ATC) - Electrical Diagnostics - 1500, 2500 & 3500)) >> DTC Troubleshooting >> B10B2-A/C Cool Down Test Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. CONDITIONS FOR A/C COOLDOWN TEST 
    1. The following condition must be met before running the A/C Cooldown test.
      • No Powertrain Control Module (PCM) DTC's present
      • Condenser cooling fan working properly
      • No active HVAC evaporator temperature sensor, sun sensor, recirculation, mode, or blend door actuator DTC's present
      • The refrigerant system must be fully charged
      • The blower motor must operate correctly in all speeds
      • The evaporator temperature must be above 12.7° C (55° F)
      • The A/C compressor must be turned off
      • Blower must be on high

      Are all of the above conditions met before running the A/C Cooldown Test?

      Yes 

      • Refer to the Service Information for additional Cooldown Test related diagnostic information and testing procedures and repair as necessary.
        NOTE:

        Run the Cooldown Test again after any repairs are performed.

      • If the Cooldown Test passes, Perform HVAC VERIFICATION TEST. Refer to HVAC VERIFICATION TEST .

      No 

      • Run the A/C Cooldown test again with the above test conditions.
scientia non olet · About LEMON Manuals