Diagnostic Test
- VERIFY ACTIVE ORC DTC NOTE:
Ensure the battery is fully charged.
- Turn the ignition on.
- Wait 12 seconds, with the scan tool, read all ORC DTCs.
Does the scan tool display active B223B-00-VEHICLE CONFIGURATION MISMATCH - DTC?
Yes
- Go To 2
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- VERIFY ORC PART NUMBER
- With the scan tool, read the ORC part number.
Is the part number correct for the vehicle?
Yes
- Go To 3
No
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the ORC module according to the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS-SYSTEM-VERIFICATION-TEST .
- With the scan tool, read the ORC part number.
- CHECK THE BCM CONFIGURATION
- With the scan tool, check for Side Airbags and PAD Switch configuration.
Does the Vehicle Configuration in the BCM match the Vehicle Configuration in the ORC?
Yes
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- Replace the ORC module according to the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS-SYSTEM-VERIFICATION-TEST .
No
- With the scan tool enter program network configuration and program the BCM to the vehicle configuration.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- With the scan tool, check for Side Airbags and PAD Switch configuration.