LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1292 ((Audio (Radio) - Electrical Diagnostics - 2500 Hd & 3500 Hd)) >> DTC Troubleshooting >> B140C-13-Rear Right Audio Speaker Output - Circuit Open - Base >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR AN INTERMITTENT CONDITION 
    1. Turn the ignition on.
    2. Using the scan tool, record and erase the Radio DTCs.
    3. Turn the Radio on.
    4. Adjust the speakers to the rear and center.
    5. Using the scan tool, read the active Radio DTCs.

      Does the scan tool read: B140C-13-REAR RIGHT AUDIO SPEAKER OUTPUT - CIRCUIT OPEN ?

      Yes 

      • Go To  2

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE RIGHT REAR SPEAKER 
    1. Turn the ignition off.
    2. Disconnect the Right Rear Speaker.
    3. Measure the resistance of the speaker between the two terminals.

      Is the resistance above 5.0 Ohms?

      Yes 

      • Replace the Right Rear Speaker in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Go To  3
  3. CHECK THE (X206) RIGHT REAR SPEAKER (+) CIRCUIT FOR AN OPEN 
    1. Disconnect the Radio C1 harness connector.
    2. Measure the resistance of the (X206) Right Rear Speaker (+) circuit between the Radio C1 connector and the Right Rear Speaker harness connector.

      Is the resistance below 5.0 Ohms?

      Yes 

      • Go To  4

      No 

      • Repair an open in the (X206) Right Rear Speaker (+) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  4. CHECK THE (X296) RIGHT REAR SPEAKER (-) CIRCUIT FOR AN OPEN 
    1. Measure the resistance of the (X296) Right Rear Speaker (-) circuit between the Radio C1 connector, and the Right Rear Speaker harness connector.

      Is the resistance below 5.0 Ohms?

      Yes 

      • Replace the Radio in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Repair an open in the (X296) Right Rear Speaker (-) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
scientia non olet · About LEMON Manuals