Lamp - Tailgate
WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This lamp is used on vehicles with a pick-up bed and dual rear wheels only. This lamp has a red lens, contains three bulbs and is located on the rearward facing surface of the pick-up bed sill panel below the tailgate.
- Disconnect and isolate the battery negative cable.
- Reach under and behind the rear bumper near the center to access and disconnect the tailgate marker lamp (3) pigtail wire connector (4) from the wire harness connector (5).
- Remove the two screws (1) that secure the tailgate marker lamp to the outer sill panel.
- Remove the lamp from the sill panel.