Lamp, Cab: Removal: Lamp
WARNING: This page is about a different car, the 2016 RAM 3500 HD and 2016 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Remove the two screws (2) that secure the cab clearance lamp lens/housing and the molded gasket (1) to the outer roof panel.
- Pull the lamp away from the roof panel far enough to access the socket (4) on the underside of the lamp lens/housing.
- Firmly grasp the lamp socket on the underside of the lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the socket and bulb straight out from the keyed opening in the housing.
- Remove the cab clearance lamp lens/housing from the roof panel.
- Remove the two plastic nuts (3) from the holes in the roof panel and discard.