When Monitored

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

Ignition is on or the TCM is in power-on state.
Engine is not in cranking mode.
Power supply must be between 7 - 24 volts.
Main Micro Processor (MMP) supply diagnostics have not failed.
Hydraulic Pressure Sensor Diagnostics have not failed.
Hydraulic pressure sensor value is greater than a minimum value.
The Even Clutch Pressure Sensor diagnostic has no electrical failure.
The 5 Volt Supply B (VS2) to the K2 Pressure Sensor has not failed.
Internal control module A/D diagnostic has not failed.