When Monitored
WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
This diagnostic runs continuously when the following conditions are met:
- Enable Conditions for Odd Gears:
- Vehicle speed is greater than a calibrated value.
- Gear shift position sensor indicates the gear is disengaged.
- Engine speed is equal to the even clutch speed or not equal to the odd clutch speed.
- Torque transmitted by the odd clutch is greater than a calibrated value.
- The calculated Transmission ratio is stable for a calibrated amount of time.
- No Gear Shift Position Sensor DTCs.
- No Engine Speed CAN message DTCs.
- No Odd Clutch Speed Sensor DTCs.
- No Even Clutch Speed Sensor DTCs.
- No Driveline Speed DTCs.
- Enable Conditions for Even Gears:
- Vehicle speed is greater than a calibrated value.
- Gear shift position sensor indicates the gear is disengaged.
- Engine speed is equal to the odd clutch speed or not equal to the even clutch speed.
- Torque transmitted by the even clutch is greater than a calibrated value.
- The calculated Transmission ratio is stable for a calibrated amount of time.
- No Gear Shift Position Sensor DTCs.
- No Engine Speed CAN message DTCs.
- No Odd Clutch Speed Sensor DTCs.
- No Even Clutch Speed Sensor DTCs.
- No Driveline Speed DTCs.
- Enable Conditions for 1st or Reverse Gear:
- The Gear Shift Position Sensor indicates that all gears are disengaged.
- No Gear Shift Position Sensor DTCs.
- No Engine Speed CAN message DTCs.
- No Odd Clutch Speed Sensor DTCs.
- No Even Clutch Speed Sensor DTCs.
- No Driveline Speed DTCs.