Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

OTHER DTCS
1. Ignition on, engine not running.
2. With the scan tool, View DTCs.
  Is DTC U010E active?
  
  Yes
  - Perform the diagnostic procedure for U010E before continuing.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Go To 2.
U040F ACTIVE
Is DTC U040F active?

Yes
- Go To 3.
No
- Perform the INTERMITTENT CONDITION - 6.7L diagnostic procedure. Refer to INTERMITTENT CONDITION - 6.7L .
CHECK THE POWERTRAIN CONTROL MODULE
1. Turn the ignition off.
2. Disconnect the DEF Dosing Control Unit harness connector.
  NOTE:
  Check connectors - Clean/repair as necessary.
3. Ignition on, engine not running.
4. With the scan tool, View DTCs.
  Is the DTC U010E active?
  
  Yes
  - Replace the DEF Dosing Control Unit in accordance with the service information. Refer to UNIT, Diesel Exhaust Fluid Dosing Control , Removal .
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Replace the Powertrain Control Module in accordance with the service information. Refer to MODULE, Powertrain Control, 6.7L Diesel [ETJ] , Removal .
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .