CHAIN and SPROCKETS, Timing: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Drain the cooling system. Refer to Standard Procedure .

Fig 1: Front Cover Slide Bushings
Courtesy of CHRYSLER LLC

NOTE:
It is not necessary to remove water pump for timing chain cover removal.
Remove the timing chain cover. Refer to COVER(S), Engine Timing, Removal, 5.7L .
Verify the slide bushings (1) remain installed in the timing chain cover during removal.

Fig 2: Oil Pump Retaining Bolts
Courtesy of CHRYSLER LLC
Remove the oil pump retaining bolts (2) and remove the oil pump (1).

Fig 3: Aligning Timing Marks With Timing Chain Sprockets
Courtesy of CHRYSLER LLC
Install the vibration damper bolt finger tight. Using a suitable socket and breaker bar, rotate the crankshaft to align the timing marks with the timing chain sprockets (1, 2).

Fig 4: Chain Tensioner Arm
Courtesy of CHRYSLER LLC
Retract the chain tensioner arm (1) until the hole in the arm lines up with the hole in the bracket.

Fig 5: Timing Chain Tensioner Pin
Courtesy of CHRYSLER LLC
Install the Tensioner Pin (special tool #8514, Pins, Tensioner) (1) into the chain tensioner holes.

Fig 6: Camshaft Phaser Retaining Bolt
Courtesy of CHRYSLER LLC

CAUTION:
Never attempt to disassemble the camshaft phaser, severe engine damage could result.
Remove the camshaft phaser retaining bolt (1) and remove the timing chain with the camshaft phaser and crankshaft sprocket.

Fig 7: Timing Chain Tensioner Pin
Courtesy of CHRYSLER LLC

NOTE:
Inspect the timing chain tensioner and timing chain guide shoes for wear and replace as necessary.
If the timing chain tensioner is being replaced, remove the retaining bolts (3) and remove the timing chain tensioner (2).

Fig 8: Timing Chain Guide
Courtesy of CHRYSLER LLC
If the timing chain guide (1) is being replaced, remove the retaining bolts (2) and remove the timing chain guide.