Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- ACTIVE DTC NOTE:
Diagnose all CAN communication DTCs before continuing.
- Turn the ignition on.
- With a scan tool, view DTCs.
Is the status Active for this DTC?
Yes
- Go To 2.
No
- Refer to Diagnosis and Testing and perform the Stored Lost Communication DTCs diagnostic procedure.
- ABS/ESP COMMUNICATION RELATED DTCS IN OTHER MODULES
- With a scan tool check for ABS/ESP communication related DTCs in other modules on the CAN Bus.
Are there any ESP communication related DTCs in other modules on the CAN Bus at this time?
Yes
- Refer to and perform the U0121-00-Lost Communication with ABS Module diagnostic procedure.
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, Powertrain Control , Removal .
- Refer to POWERTRAIN VERIFICATION TEST and perform the POWERTRAIN VERIFICATION TEST.
- With a scan tool check for ABS/ESP communication related DTCs in other modules on the CAN Bus.