LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas/Ethanol >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lamps/Lighting - Exterior (Service Information) >> Smart Beam >> Standard Procedure >> Standard Procedure - Smart Beam Calibration >> Calibration Procedure

Calibration Procedure

  1. Connect a diagnostic scan tool to the Data Link Connector (DLC) below the driver side end of the instrument panel.
  2. Turn the ignition switch to the ON position.
  3. Use the diagnostic scan tool to enter the SmartBeam unit into calibration mode. Look in the diagnostic scan tool under the SmartBeam®  or AUTOMATIC HIGH BEAM MODULE/AHBM  menu item as appropriate. When the SmartBeam® unit has entered calibration mode, it will be indicated by a continual flashing of the ElectroChromic (EC) mirror red LED at a slow rate of once-per-second.
  4. Connect the aim board transformer to illuminate the aim board LED units. The EC mirror red LED will continue to flash for five to ten seconds, then will stop flashing to indicate that it has completed calibration. If the LED illuminates continually (solid), it indicates that the calibration has failed and a Diagnostic Trouble Code (DTC) has been recorded. Use the diagnostic scan tool to retrieve the DTC, then refer to the appropriate diagnostic information.
scientia non olet · About LEMON Manuals