LAMP, Side Repeater: Removal: Bulb
NOTE:
Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
- Disconnect and isolate the battery negative cable.
- Remove the repeater lamp from the fender mounting hole, but do not disconnect the wire harness connector. Refer to LAMP, Side Repeater, Removal .
- Firmly grasp the bulb socket (1) on the back of the lamp lens/housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the socket and bulb straight out from the keyed opening in the housing.
- Pull the base of the bulb (3) straight out of the socket.