Instrument Cluster (Service Information): Removal: Removal: SEBRING

Fig 1: Removing/Installing Cluster

Courtesy of CHRYSLER LLC

1. Disconnect and isolate the battery negative cable.
2. Remove the instrument cluster bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
3. Remove the four retaining screws (1) to the instrument cluster, (only two upper screws on Dodge).
   Fig 2: Cluster Bezel From Cluster

   Courtesy of CHRYSLER LLC
4. Pull instrument cluster rearward to expose the four electrical connectors.
5. Disconnect the electrical connectors and remove cluster from instrument panel.
6. Separate cluster bezel from cluster by removing the four retaining screws (1).