Water Pump - Assembly

WATER PUMP - GAS ENGINE





1. Throughly clean all gasket mating surfaces before assembling.
2. Inspect water pump and components for any damage.
3. Using bolts (3), install the water pump (4) and gasket (8) to the water pump adapter (6). Tighten the bolts (3) to 22 N-m (16 lbs. ft.)
4. Using bolts (1), install the water pump pulley (2) to the water pump (4). Tighten the bolts (1) to 9 N-m (80 lbs. in.)
5. Using bolts (5), install the water pump assembly and gasket to the engine block. Tighten the bolts to 24 Nm (18 lbs. ft.).Water Pump - Installation
6. Start the engine and check for leaks. Testing and Inspection