62TE Automatic Transaxle

ADJUSTMENT - INTERLOCK CABLE










1. Remove the center console Shifter Housing - Removal.
2. Move the gear shifter to PARK and the ignition key to the LOCK position.










3. If the interlock cable is being replaced, remove the pin to allow cable to "self adjust." Press locking clip by hand to secure adjustment.
4. If the interlock cable is not being replaced, the pin will not exist. Loosen the locking clip on the interlock cable to allow cable to "self adjust." Press locking clip by hand to secure adjustment.
5. Install the center console Shifter Housing - Installation.






6. Install the bezel on the shifter console.
7. Install shifter handle.