Erasing Homelink(R) Transceiver Codes

ERASING HOMELINK(R) TRANSCEIVER CODES

NOTE: Individual channels cannot be erased. Erasing the HomeLink(R) transceiver codes will erase ALL programmed codes.

To erase programming from all three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

- Press and hold the two outer HomeLink(R) transceiver buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or learning) mode and can be programmed at any time beginning with "Programming" Programming and Relearning.