Removal

REMOVAL

Non - Turbo










1. Remove front fascia Front Bumper Fascia - Removal.

NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.

2. Disconnect hoses (3) from transmission oil cooler (2), Service and Repair.
3. Remove screws (4) attaching transmission oil cooler (2) to radiator.
4. Remove transmission oil cooler (2).

Turbo





NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.

1. Remove grille Grille - Removal.
2. Remove upper radiator closure panel (1).Radiator Upper Crossmember - Removal
3. Remove radiator closure panel center brace (2).










4. Remove fasteners (2) attaching transmission oil cooler (1) to air conditioning condenser.
5. Disconnect lines from transmission oil cooler, Service and Repair.
6. Remove transmission oil cooler (1).