A/C High Pressure Cut Off Switch - Removal

REMOVAL

WARNING: Review safety precautions and warnings before performing this procedure Warning and Caution . Failure to follow these instructions may result in possible serious or fatal injury.





1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system Refrigerant System Recovery.
3. Raise and support the vehicle.
4. Disconnect the wire harness connector (1) from the A/C high pressure switch (2) located at the rear of the A/C compressor (3).
5. Using snap ring pliers (Special Tool C-4574 or equivalent), remove the internal snap ring that secures the A/C high pressure switch to the A/C compressor.
6. Remove the A/C high pressure switch from the A/C compressor and remove and discard the O-ring seal.