Instrument Panel Demister Duct - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.






NOTE: Driver side duct shown. Passenger side duct similar.

1. Remove the instrument panel top cover Instrument Panel Cover - Removal.
2. Remove the four screws (1) that secure each demister duct (2) to top the instrument panel (3), as required
3. Disconnect each demister duct from the defroster duct (4), as required.
4. Remove demister duct(s) from the instrument panel.