Water Pump Inlet Tube - Removal

WATER PUMP INLET TUBE










The water pump inlet tube connects the water pump to the radiator and heater core. This tube is sealed by an O-ring and held in place by fasteners to the block.

CAUTION: Do not use any sharp tools to remove hoses from inlet tube. This may cause the tube to leak.

1. Drain cooling system Service and Repair.
2. Remove upper radiator closure panel and center brace Radiator Upper Crossmember - Removal.
3. Remove lower radiator hose and heater return hose from the inlet tube (3).
4. Remove the inlet tube to block bolts.
5. Rotate tube while removing from the engine block.