Right Cylinder Head Cover(s)

REMOVAL

WARNING: Do not start or run the engine with the cylinder head cover removed. Damage or personal injury may occur.

1. Disconnect the negative battery cable.
2. Remove the upper intake manifold from the engine Intake Manifold - Removal.
3. Cover lower intake manifold intake ports with a clean cover to prevent dirt or debris from entering the ports during service.









4. Disconnect the ignition coil harness connectors (2).
5. Remove ignition coils Ignition Coil - Removal.
6. Disconnect the engine wiring harness retainers (1) from the valve cover.
7. Disconnect the makeup air hose (3).
8. Completely loosen the cylinder head cover retaining bolts (4) and remove the cylinder head cover.