Retractable Hard Top - Rear Panel

REAR PANEL





1. With the help of assistant, place the rear panel (4) into position and loosely install the top fastener on each side, to hold it in place.
2. Align the rear panel to the marks on the bracket made during removal.
3. Install the fasteners to the rear panel. Tighten to 20 N-m (15 ft. lbs.).
4. Install the lower fastener (2) on each side. Tighten to 20 N-m (15 ft. lbs.).
5. Install the heated glass harness to the rear panel and connect the electrical connectors.
6. Install the mid/rear headliner. Convertible Top Headliner - Installation.
7. Cycle the convertible top and verify operation.