Stack Cylinder Position

INSTALLATION





1. Position the folding top stack cylinder position switch (2) onto the folding top stack cylinder (3).
2. Secure the position switch to the folding top stack cylinder. Push the switch retainer (4) over the switch (2). Push the position switch retainer locking tab (1) towards the retainer (4) until the two are fully engaged.





3. Connect the position switch (4) wire harness routing clips to the left inner quarter panel.
4. Connect the folding top stack cylinder position switch electrical connector.
5. Position the cylinder onto the vehicle main pivot bracket assembly (3) and install the retaining pin and clip (2).
6. Install the left and right trunk trim panels.
7. Install the rear trunk trim panel.
8. Close the rear decklid.
9. Connect the battery negative cable.