Tonneau Retracted Switch - Installation

INSTALLATION





1. Position the tonneau retracted limit switch (2) onto the four bar linkage (4). Ensure the switch sensing tab (1) is located properly so that the screw drive assembly makes contact with the tonneau cover fully retracted.
2. Install the two switch retaining screws (6).
3. Connect the switch electrical connector (5).
4. Connect the battery negative cable.
5. Using a diagnostic scan tool, enter the "Power Folding Top Misc. Functions". Select the "Manual Top Movement" menu and manually activate the tonneau drive motor to the tonneau fully retracted position.
6. Cycle the power folding top and ensure proper alignment of the tonneau cover assembly. Make adjustments as necessary.
7. Install the left and right trunk trim panels.
8. Install the rear trunk trim panel.
9. Close the rear decklid.