Cylinder, Folding Top Hydraulic: Removal: DECKBAR

Fig 1: Hydraulic Pump Valve

Courtesy of CHRYSLER LLC

OPEN	COUNTER CLOCKWISE (CCW) DIRECTION (1)
CLOSE	CLOCKWISE (CW) DIRECTION (2)

NOTE: The hydraulic system uses ARAL VITAMOL ZH-M fluid. When replacing components or topping off system due to leak, make sure to use only approved fluid. When adding fluid. See Body/Convertible Top - Standard Procedure .

1. Open decklid conventionally,
2. Disconnect and isolate the battery negative remote cable.
3. Remove the rear and side trunk trim panels. See Body/Interior/PANEL, Trunk Trim - Removal .
4. Remove the spare tire cover/floor of the trunk.
5. Release the pump pressure valve (3) by turning it two rotations counter clockwise (1).
   Fig 2: Support Cylinder

   Courtesy of CHRYSLER LLC
6. Using a small flat bladed tool or equivalent, release the retaining clips while pulling the ball socket away from the ball stud.
   Fig 3: Cylinder Mounting Plate Fasteners & Cylinder

   Courtesy of CHRYSLER LLC
7. Remove the cylinder mounting plate fasteners (2) and remove the cylinder (1) from the vehicle.
   Fig 4: Hydraulic Cylinder Hall Effect Switch

   Courtesy of CHRYSLER LLC
8. At the hydraulic cylinder, slide the retaining clamp off and pull out line.
   CAUTION: Be careful to catch all fluid in a catch container.
9. Remove the hall effect on the left cylinder. Refer to Electrical - Power Systems/Power Top/SWITCH, Power Top - Removal .