LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Seats, Front Convertible >> Pan, Seat Cushion, Front >> Removal >> Removal

Pan, Seat Cushion, Front: Removal: Removal

  1. Remove seat from vehicle. See Body/Seats/SEAT - Removal 
  2. Remove seat side shields. See Body/Seats/SIDE SHIELDS, Seat Cushion - Removal 
    Fig 1: REAR SHIELD
    GC0123035Courtesy of CHRYSLER LLC
  3. Remove the rear outer shield (2).
  4. Disengage the seat back cover (1) J-clips from the inner shield.
    Fig 2: INNER SHIELD
    GC0123036Courtesy of CHRYSLER LLC
  5. Carefully pull the seat back cover up to gain access to the inner shield.
  6. Remove the mounting fasteners (1) and inner shield (2).
    Fig 3: RETRACTOR
    GC0123037Courtesy of CHRYSLER LLC
  7. Remove the seat belt retractor mounting bolt (3) and push retractor aside.
  8. Disengage the seat cushion cover J-clip (1).
  9. Disconnect the electrical harness from the seat pan.
  10. Remove four seat pan fasteners.
  11. Remove the seat cushion and pan from the seat frame.
scientia non olet · About LEMON Manuals