Diagnostic Test

RECONFIGURE THE TOTALLY INTEGRATED POWER MODULE
1. Turn the ignition on.
2. With the scan tool, select network view and press the gateway button. This will list the CAN modules on the vehicle. Read and record the listed modules.
3. With the scan tool, select TIPM, miscellaneous functions then add/remove ECUs.
4. With the scan tool, add or remove the module that was not configured in the TIPM.
5. With the scan tool, erase DTCs.
6. Cycle the ignition from on to off 3 times and read the active TIPM DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Retest system and attempt to reconfigure the TIPM.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Repair is complete.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .