Diagnostic Test

FUEL PUMP CLUTCH OPERATION
1. Ignition on, engine not running.
2. With a scan tool in the TIPM Actuators, actuate the Fuel Pump.
  Is the Fuel Pump operating?
  
  Yes
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Go to step 2
VISUAL AND PHYSICAL CONNECTOR AND TERMINAL INSPECTION
1. Turn the ignition off.
2. Disconnect the TIPM C7 harness connector.
3. Disconnect the Fuel Pump harness connector.
4. Inspect the terminal and connector condition. Check for signs of corrosion build up or damage the would compromise the terminal to controller pin connector.
  NOTE: Make sure that all in-line connectors are inspected for corrosion and/or damage.
5. Visually inspect the wiring harness. Look for any chafed, pierced, pinched or partially broken wires hidden in the wire insulation.
  Were any of the above conditions found?
  
  Yes
  - Repair or replace as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Go to step 3
(N1) FUEL PUMP CONTROL OUTPUT CIRCUIT HIGH RESISTANCE
1. With a jumper wire, connect one end to the (N1) Fuel Pump Control Output circuit in the Fuel Pump harness connector and the other to a clean chassis ground.
2. Using a 12-volt test light to battery voltage, probe the (N1) Fuel Pump Control Output circuit in the TIPM C7 harness connector.
  NOTE: The test light should be illuminated and bright. Compared the brightness to that of a direct connection to the battery.
  
  Does the test light illuminate brightly.
  
  Yes
  - Go to step 4
  No
  - Repair the high resistance in the (N1) Fuel Pump Control Output circuit.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
FUEL PUMP GROUND CIRCUIT
1. Using a 12-volt test light to battery voltage, probe the (Z904) Fuel Pump Ground circuit in the Fuel Pump harness connector.
  NOTE: The test light should be illuminated and bright. Compared the brightness to that of a direct connection to the battery.
  
  Does the test light illuminate brightly.
  
  Yes
  - Go to step 5
  No
  - Repair the excessive resistance in the (Z904) Fuel Pump Ground circuit.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
FUEL PUMP CONTROL OUTPUT FROM TIPM
1. Reconnect the TIPM C7 harness connector.
2. Ignition on, engine not running.
3. With a scan tool in the TIPM Actuators, actuate the Fuel Pump.
4. Using the 12-volt test light connected to ground, probe the (N1) Fuel Pump Control Output circuit in the Fuel Pump harness connector.
  Does the test light illuminate brightly?
  
  Yes
  - Replace the Fuel Pump.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Replace the Totally Integrated Power Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .