Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Headlamps on.
4. With the scan tool read the DTC information.
  Does the scan tool read: B1638-RIGHT HI BEAM CONTROL CIRCUIT HIGH?
  
  Yes
  - Go to step 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
RIGHT LOW BEAM BULB
1. Turn the ignition off.
2. Inspect the Right High Beam Bulb Assembly.
  Is the inoperative bulb OK?
  
  Yes
  - Go to step 3
  No
  - Replace the Inoperative bulb in accordance with the service information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
(L34) HIGH BEAM CONTROL CIRCUIT OPEN

Fig 1: Checking High Beam Control Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the TIPM C4 harness connector.
3. Disconnect the Right Highbeam Lamp harness connector.
4. Measure the resistance of the (L34) High Beam Control circuit.
  Is the resistance above 5.0 Ohms?
  
  Yes
  - Repair the (L34) High Beam Control circuit for an open condition.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to step 4
(L34) HIGH BEAM CONTROL CIRCUIT SHORT TO VOLTAGE

Fig 2: Checking High Beam Control Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the TIPM C4 harness connector.
3. Disconnect the Right Highbeam Lamp harness connector.
4. Turn the ignition on.
5. Measure for voltage on the (L34) High Beam Control circuit.
  Is the voltage above 10.0 volts?
  
  Yes
  - Repair the (L34) High Beam Control circuit for a short to voltage condition.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Totally Integrated Power Module (TIPM) in accordance with the service information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .