Diagnostic Test

VERIFY THAT DTC B2201-CALIBRATION MISMATCH IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
  NOTE: Ensure the battery is fully charged.
  
  Does the scan tool display active: B2201-CALIBRATION MISMATCH?
  
  Yes
  - Go to step 2
  No
  - Test Complete.
CHECK VIN IN PCM
1. With the scan tool compare the VIN that is programmed into the PCM to the VIN stored in the ORC.
  Does the VIN programmed into the PCM match the VIN stored in the ORC?
  
  Yes
  - Go to step 3
  No
  - Replace and program the Powertrain Control Module in accordance with the service information. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure . Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure . Ensure the PCM is replaced with the correct vehicle line PCM.
REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

View repair.

Repair
- Replace the Occupant Restraint Controller in accordance with the service information.
- Perform the ORC VERIFICATION TEST. See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .