Charging Procedure

CAUTION: A small amount of refrigerant oil is removed from the A/C system each time the refrigerant system is recovered and evacuated. Before charging the A/C system, you MUST replenish any oil lost during the recovery process. See the equipment manufacturer instructions for more information.

Evacuate the refrigerant system. See Heating and Air Conditioning/Plumbing - Standard Procedure .
A manifold gauge set and an R-134a refrigerant recovery/recycling/charging station that meets SAE standard J2788 should be connected to the refrigerant system.
Measure the proper amount of refrigerant and heat it to 52° C (125° F) with the charging station. See Heating and Air Conditioning/Plumbing/REFRIGERANT - Specifications . See the operating instructions supplied by the equipment manufacturer for proper use of this equipment.
Open both the suction and discharge valves, then open the charge valve to allow the heated refrigerant to flow into the system.
When the transfer of refrigerant has stopped, close both the suction and discharge valves.
If all of the refrigerant charge did not transfer from the dispensing device, open all of the windows in the vehicle and set the heating-A/C system controls so that the A/C compressor is operating and the blower motor is running at its lowest speed setting. Run the engine at a steady high idle (about 1400 RPM).
Open the low-side valve to allow the remaining refrigerant to transfer to the refrigerant system.
WARNING: Take care not to open the discharge (high pressure) valve at this time. Failure to follow this warning may result in possible serious or fatal injury.
Disconnect the charging station and manifold gauge set from the refrigerant system service ports.
Reinstall the caps onto the refrigerant system service ports.