Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Wait 30 seconds.
4. With the scan tool, read DTCs.
  Does the scan tool display: B2143-UGDO ENABLE CONTROL CIRCUIT?
  
  Yes
  - Go to step 2
  No
  - The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chaffed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure
(G38) UGDO ENABLE CONTROL CIRCUIT SHORT TO VOLTAGE

Fig 1: Checking UGDO Enable Control Circuit Short To Voltage
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Instrument Cluster C2 harness connector.
3. Disconnect the Left Vanity Lamp Harness connector.
4. Turn the ignition on.
5. Measure the voltage of the (G38) UGDO Enable Control Circuit.
  Is voltage present?
  
  Yes
  - Repair the (G38) UGDO Enable Control Circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure
  No
  - Go to step 3
(G38) UGDO ENABLE CONTROL CIRCUIT SHORT TO GROUND

Fig 2: Checking UGDO Enable Control Circuit Short To Ground
Courtesy of CHRYSLER LLC
1. Measure the resistance between ground and the (G38) UGDO Enable Control Circuit.
  Is the resistance below 10K ohms?
  
  Yes
  - Repair the (G38) UGDO Enable Control Circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure
  No
  - Go to step 4
(G38) UGDO ENABLE CONTROL CIRCUIT OPEN

Fig 3: Checking UGDO Enable Control Circuit Open
Courtesy of CHRYSLER LLC
1. Measure the resistance of the (G38) UGDO Enable Control Circuit.
  Is the resistance above 10K ohms?
  
  Yes
  - Repair the (G38) UGDO Enable Control Circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure
  No
  - Replace the Instrument Cluster in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure