ASSEMBLY, Transmission Solenoid and Pressure Switch: Removal: Removal

Fig 1: Air Cleaner Assembly Removal/Installation

Courtesy of CHRYSLER LLC

1 - AIR CLEANER ASSEMBLY

1. Disconnect the battery cables.
2. Remove air cleaner assembly (2) .
   Fig 2: Battery Removal/Installation

   Courtesy of CHRYSLER LLC

   1 - BATTERY

3. Remove the battery hold down clamp and remove the battery (1) .
   Fig 3: Battery Tray Removal/Installation

   Courtesy of CHRYSLER LLC
4. Remove the battery tray (1) .
   Fig 4: Input Speed Sensor

   Courtesy of CHRYSLER LLC

   1 - INPUT (TURBINE) SPEED SENSOR

5. Disconnect and remove the input speed sensor (1) .
6. Disconnect the transmission oil cooler lines. Cap off hoses and fittings to prevent foreign matter intrusion.
7. Disconnect the solenoid/pressure switch assembly connector.
   Fig 5: Attaching Bolts

   Courtesy of CHRYSLER LLC

   1 - BOLTS

   2 - SOLENOID AND PRESSURE SWITCH ASSEMBLY

8. Remove the three solenoid/pressure switch assembly-to-transaxle case bolts (1) .
   Fig 6: Solenoid/Pressure Switch Assembly and Gasket

   Courtesy of CHRYSLER LLC

   1 - SOLENOID/PRESSURE SWITCH ASSEMBLY

   2 - GASKET

9. Remove solenoid/pressure switch assembly (1) and gasket (2) .
   CAUTION: Be sure to keep foreign material from entering ports in transaxle case. Erratic transaxle operation and/or failure can result.