Switch, Clutch Starter Interlock And UPSTOP: Removal: RHD
WARNING: This page is about a different variant/trim than selected.
- Remove lower instrument panel bezel (2). See Fig 1.
1 - INTERLOCK/UPSTOP SWITCH 2 - CLUTCH MASTER CYLINDER 3 - CONNECTOR - Disconnect the master cylinder push rod from the pedal pin. Inspect push rod retainer for damage. If it is damaged (broken/cracked), it must be replaced.
- Squeeze together the tangs on the switch cover plate and slide the plate off the switch housing.
- Disconnect the clutch interlock/upstop switch connector (3) from the instrument panel wiring harness. See Fig 2.
- Remove the switch (1) from the vehicle.