Disc, Clutch: Removal: 1.6L

WARNING: This page is about a different variant/trim than selected.

Fig 1: Clutch Disc & Pressure Plate

Courtesy of CHRYSLER LLC

1 - FLYWHEEL

2 - CLUTCH DISC

3 - PRESSURE PLATE

4 - BOLT (6)

WARNING: Chrysler does not manufacture any vehicles or replacement parts that contain asbestos. Aftermarket products may or may not contain asbestos. Refer to aftermarket product packaging for product information. Whether the product contains asbestos or not, dust and dirt can accumulate on manual clutch parts during normal use. Follow practices prescribed by appropriate regulations for the handling, processing and disposing of dust and debris

Remove transaxle. Refer to REMOVAL
Mark position of pressure plate on flywheel (1) with paint or a scriber for assembly reference. See Fig 1.

Loosen and remove six pressure plate-to-flywheel bolts (4). Remove pressure plate (3) and clutch disc (2).

Fig 2: Flywheel-To-Crankshaft

Courtesy of CHRYSLER LLC

1 - FLYWHEEL

2 - BOLT (8)

3 - CRANKSHAFT FLANGE

Remove eight flywheel-to-crankshaft bolts (2) and remove flywheel (1). See Fig 2.

Fig 3: Release Bearing and Lever
Courtesy of CHRYSLER LLC

1 - RELEASE BEARING

2 - LEVER
Inspect release lever (2) and bearing (1). See Fig 3. Replace as necessary. See Clutch/BEARING, Clutch Release - Removal .