Diesel And Turbo Models

WARNING: This page is about a different variant/trim than selected.

Fig 1: CSC Removal/Installation

Courtesy of CHRYSLER LLC

1 - CONCENTRIC SLAVE CYLINDER

Install slave cylinder (1) to transaxle using new bolts. See Fig 1.
NOTE: Torque three CSC body screws first, then torque the fluid tube attachment.
Torque slave cylinder-to-case bolts in three steps:
1. 2 N.m (18 in. lbs.)
2. 5 N.m (44 in. lbs.)
3. 8.4 N.m (74 in. lbs.)
Install transaxle. Refer to INSTALLATION .
Bleed clutch hydraulic system. See Clutch - Standard Procedure .