1.6L/2.4L MODELS (Except Diesel and Turbo)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Hydraulic Tube Retaining Clips

Courtesy of CHRYSLER LLC

1 - RETAINER CLIPS

Connect slave cylinder to hydraulic tube. Press both retainer clips (1) to secure tube in cylinder. See Fig 1.

Fig 2: Clutch Slave Cylinder at Transaxle-1.6L Models
Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BOLT
On 1.6L only, install the slave cylinder assembly (1) into position on transaxle and tighten bolts (2) to 12 N.m (105 in. lbs.).

Fig 3: Clutch Slave Cylinder at Transaxle-2.4L Models
Courtesy of CHRYSLER LLC

1 - SLAVE CYLINDER

2 - BRACKET
On 2.0L/2.4L only, install the slave cylinder assembly (1) into position on transaxle and tighten bolts to 19 N.m (168 in. lbs.). See Fig 2 or Fig 3 .
Lower vehicle.
Verify brake master cylinder reservoir is full. Top off with DOT 3 brake fluid if necessary.
Bleed clutch hydraulic system. See Clutch - Standard Procedure .
Verify proper clutch release system operation.